SenseCAP M1
General Information
Last updated
Was this helpful?
General Information
Last updated
Was this helpful?
SenseCAP M1 is a high-performing, ready-to-use LoRaWAN indoor gateway connected to the Helium LongFiTM Network.
It is based on Raspberry Pi 4 and embedded with a WM1302/WM1303 (Semtech SX1302/SX1303) LoRa concentrator. It provides built-in BLE, which helps you set up the device in a few simple steps and supports connecting to the internet via Wi-Fi or Ethernet.
Handy Setup to Helium Network: Ready to go within simple steps.
Powered by Mature Hardware Solutions: Raspberry Pi 4(2G/4G/8G RAM, 64G storage) and WM1302/WM1303 (Semtech SX1302/SX1303) baseband LoRa chip.
Secure and Reliable: Built-in ECC608 crypto chip, high-security authentication, and reliable connectivity.
Automatic Online Upgrades: Automatic OTA upgrades, without manual operation.
Remote Diagnosis: Built-in remote diagnostics mechanism, efficient online support.
64GB Large Storage: 64GB MicroSD card large storage, extending the lifetime of the gateway, fulfilling the memory requirement of potential upgrade.
Efficient Cooling Solution: Aluminum enclosure with a heatsink and cooling fan inside, ensuring long-term and stable operation.
Multiple Accessories: Fiberglass antenna, slider pad for sliding rod installation, and upcoming outdoor enclosure, etc.
FCC and CE Certificated: Available for personal and commercial use.
SenseCAP M1 LoRaWAN Indoor Gateway (EU868/US915) *1
Power Adapter (EU/US)*1
Antenna (EU868/US915) *1
64GB MicroSD Card *1
Quick Start Guide *1
Device Size (/pcs): 154*100*44 mm
Device Weight (/pcs): 370g
Package Size (/pcs): 274*175*60 mm
Package Weight (/pcs): 675g
There are two sticker labels on the bottom of the SenseCAP M1.
These two labels on the bottom indicate important information of the unit including:
Model
S/N
WiFi MAC
ETH MAC
CPU ID
This information will be required when registering for the SenseCAP Dashboard
